425 HTTP Error

[Cluster]

Någon som vet vad "425 HTTP Error" betyder som

kommer upp när jag dörsöker se mina websidor som ligger på en Algonet server?

[PKaze]

Hej!

 

Enligt http://www.k-c-p.com/html/october_2000_gaffe.htm verkar det felmeddelandet komma upp när servern är överbelastad och inte kan upprätta en anslutnign till din webbläsare...

 

Kan du posta länken till dina sidor?

 

/Cyradis

 

 

 

 

[Gunnar Dahlström]

Intressant, hur kan den då skicka felmeddelandet till webläsaren om den inte kan upprätta en anslutning? :-))

 

//GunnarD

 

 

[Nollis]

Tjena!

 

Utan att egentligen ha något kött på benen ang. detta, så kan man väl tänka sig att felmeddelandet uppstår helt och hållet på klientsidan...?

 

/ Johan

 

 

[Webster]

Verkar inte vara någon giltig felkod enligt HTTP/1.1, kolla här:

 

http://www.w3.org/Protocols/rfc2068/rfc2068

 

Tjing

 

 

 

 

[Nollis]

Tjena!

 

Efter en, om jag får säga det själv, heroisk insats med riktig hard core-sökning på google, har jag kommit fram till följande fakta.

 

1. Det är ett proxy-problem

2. Det finns en del info om denna felkod:

 

"425 "Connection Errors"

"Unable To Connect To Remote Host" or "Connection Refused by Remote Host". Either the host is not accepting connections or there was a network error (during setup an error in local IP addressing might cause this). WinProxy tried to establish a connection to a server but the server either refused the connection or was not available. This could indicate that the remote server is down, or the name or IP address specified is incorrect, or the appropriate server is not running on the specified machine.

"Connection Refused. Too many people are already using WinProxy. Try again later." In WinProxy Lite, this is returned to indicate that the simultaneous three user limitation has been reached.

"Connection refused. You are not authorized to use the specified protocol through WinProxy". If users are configured, then this message indicates that the particular user requesting the connection does not have permission to use the requested protocol. It is also possible that a connection was requested and the required protocol was not required. User configuration is available in WinProxy -> File -> Advanced Properties -> Users. Protocol configuration is available in WinProxy -> File -> Advanced Properties -> Protocols.

"Unable to establish PASV FTP connection". The FTP server returned an error to the PASV command. This is only returned if the checkbox in FTP setup states that all the ftp transactions should use PASV mode. That checkbox should only be set if you are running behind a filtering router, which does not permit incoming connections. "

 

http://www.ositis.com/english/support/WinProxy2/sp_error_codes2_en.asp#WinProxy Error Messages

 

Over and out...

 

/ Johan