Western Digital Caviar WD1600JD 160Gb

[asdasdaas]

non som vet vad för pot master o slave ska sittar? jag kan inte hittar non bild på det. skickar svar till Zomme80@hotmail.com snälla

 

[Stefan Eklinder]

http://www.sequimpc.com/hard_drives.htm

 

[log]Cable Select Configuration

Cable Select requires a special cable (included in your kit). If your system supports Cable

Select, there is no need to reposition the jumper shunt on the drive. If you are installing your new Western Digital hard drive with an existing IDE drive on the cable, make sure that the other drive is also jumpered as Cable Select. If your system does not support Cable Select or if you are uncertain, use the Master/Slave configuration.

 

Standard Jumper Settings

If you determined that your system does not support Cable Select or if you are uncertain, use

the following information to properly jumper your new Western Digital IDE hard drive.

NOTE: Not all hard drive manufacturers use the same jumper configurations. If you are

installing your new Western Digital hard drive along with a non Western Digital hard

drive, obtain jumper setting information from the original hard drive manufacturer.

 

Single Configuration

Single - Installing the new drive as the only drive in the system:

If installing your new Western Digital hard drive as the only IDE device on the cable, then move the jumper shunt on the drive to pins 4 and 6.

 

Master/Slave Configuration

To set up the Master/Slave configuration, one device on the cable must be jumpered as Master (designated as the primary device) and the other jumpered as Slave (designated as thesecondary device).

If multiple IDE ports are used, each port has its own Master/Slave configuration. The primary IDE port is ordered first, then the secondary, and so forth. Therefore, it is possible to have two Master drives and two Slave drives.

 

Master - Installing the new drive as the primary drive:

If installing your new Western Digital hard drive as the Master drive on the cable with two IDE devices, then move the jumper on the drive to pins 5 and 6. Next configure the

jumper on the other IDE device as Slave.

Slave - Installing the new drive as the secondary drive:

If installing your new Western Digital hard drive as the secondary drive on the cable with two IDE devices, move the jumper shunt on the drive to pins 3 and 4. Next configure the jumper on the other IDE device as Master.

[/log]

 

Jumpersettings på bild här:

http://eshop.macsales.com/Tech/manuals/idehdsettings/WD72.pdf

 

---

C:\Eforum\Stefan Eklinder>|

 

"Det finns två företeelser som är oändliga, universum och den mänskliga dumheten. Jag är dock inte säker på den förstnämnda."

 

- Albert Einstein

 

-->Passerade 10.000 inlägg den 1 maj 2005 kl: 16.48<--

 

[inlägget ändrat 2005-06-14 17:27:15 av Stefan Eklinder]